How To Remove a Schlage Touchscreen Deadbolt (BE375 Model)

To remove a Schlage Touchscreen Deadbolt (model BE375), simply reverse the lock's installation steps: remove the batteries, disconnect the interior thumbturn assembly, detach the wiring, and then take off the exterior touchscreen and the bolt from the door. This process, which requires only a Phillips screwdriver, is the same for homeowners who are replacing the lock, moving, or performing maintenance.

Understanding the Schlage Touchscreen Deadbolt

The lock has a built-in alarm system that can detect and alert homeowners to potential break-ins. It is equipped with a low battery indicator. The lock is available in a variety of finishes to match existing decor.

Before you start: is this your lock?

The steps differ for Schlage Sense, Connect, or Encode models. If your lock connects to a phone app or uses Wi-Fi, stop here and confirm your specific model number before proceeding.

Tools and materials you will need

Phillips screwdriver
Replacement 9-volt alkaline battery (if you plan to reuse the lock afterward)
A safe place to store screws and small parts
A hex key may be needed if the deadbolt has set screws that require one.
A tape measure is useful if installing a new deadbolt in the same location to ensure proper alignment and placement.
Pliers can be useful for gripping and holding small parts during the removal process.

How to remove a Schlage touchscreen deadbolt

Open the door and retract the bolt completely. The bolt must stay retracted throughout removal to avoid damage.
Place a strip of tape on the door surface around the deadbolt to protect the finish from scratches.
Slide the battery cover upward off the interior side of the lock.
Remove the battery and disconnect any wiring so the interior assembly can be handled safely.
Remove the two screws that hold the interior thumbturn assembly to the door.
Disconnect the wire running between the touchscreen and the interior assembly.
Pull the interior thumbturn assembly away from the door.
Simultaneously press the release tabs or buttons located on both sides of the exterior portion of the deadbolt to slide it away from the door, then remove the exterior touchscreen assembly from the outside.
Remove the bolt from the door edge by taking out the screws on the latch and sliding the bolt out of the edge bore.
If replacing the lock, also remove the strike from the door frame. If reusing the same strike with another lock, leave it in place.
Clean the deadbolt components with a mild cleaner and a soft cloth and inspect all parts for any signs of damage or wear.

Frequently Asked Questions

Does Schlage offer an app or phone menu path for removing this lock?

No. The Touch deadbolt (BE375) is a standalone, battery-powered lock. Its official documentation does not include an iPhone, Android, or carrier app removal path, so it cannot be uninstalled via any phone accessories and maintenance menu.

What model is this removal process for?

This is the process for the Schlage Touch Deadbolt, model BE375.

Is a special tool required to remove the lock?

No. Schlage specifies only a Phillips screwdriver for installation, and no special removal kit or additional tools are needed to take the lock apart.

Are there differences between Schlage touchscreen models?

Yes. Schlage provides separate guidance for Sense, Connect, and Encode models. The removal steps can vary, so confirm the model before beginning work on a lock that uses Bluetooth or Wi-Fi.